•  

PlaceOnHost Method

Places the part on the specified host.

Namespace: Autodesk.Revit.DB
Assembly: RevitAPI (in RevitAPI.dll) Version: 17.0.0.0 (17.0.484.0)
Since: 2016

Syntax

C# 
public void PlaceOnHost(
	ElementId hostId,
	Connector hostConnector,
	double distance
)
Visual Basic 
Public Sub PlaceOnHost ( _
	hostId As ElementId, _
	hostConnector As Connector, _
	distance As Double _
)
Visual C++ 
public:
void PlaceOnHost(
	ElementId^ hostId, 
	Connector^ hostConnector, 
	double distance
)

Parameters

hostId
Type: Autodesk.Revit.DB ElementId
Id of the host fabrication part.
hostConnector
Type: Autodesk.Revit.DB Connector
The connector of the host.
distance
Type: System Double
The distance from the connector to place the hosted part. Units are in feet (ft).

Remarks

The document must be regenerated before the fabrication part can be used. Check ValidationStatus after regeneration to see if the part is valid for fabrication.

Exceptions

Exception Condition
Autodesk.Revit.Exceptions ArgumentException Invalid fabrication part host. The host should be a straight fabrication part. -or- The distance is out of range.
Autodesk.Revit.Exceptions ArgumentNullException A non-optional argument was NULL

See Also