•  

BentFabricWiresOrientation Property

Specifies the location of the straight bars in the fabric sheet.

Namespace: Autodesk.Revit.DB.Structure
Assembly: RevitAPI (in RevitAPI.dll) Version: 17.0.0.0 (17.0.484.0)
Since: 2016

Syntax

C# 
[ObsoleteAttribute("This property is obsolete in Revit 2017. Use BentFabricStraightWiresLocation instead.")]
public BentFabricWiresOrientation BentFabricWiresOrientation { get; set; }
Visual Basic 
<ObsoleteAttribute("This property is obsolete in Revit 2017. Use BentFabricStraightWiresLocation instead.")> _
Public Property BentFabricWiresOrientation As BentFabricWiresOrientation
	Get
	Set
Visual C++ 
[ObsoleteAttribute(L"This property is obsolete in Revit 2017. Use BentFabricStraightWiresLocation instead.")]
public:
property BentFabricWiresOrientation BentFabricWiresOrientation {
	BentFabricWiresOrientation get ();
	void set (BentFabricWiresOrientation value);
}

Remarks

This property applies only to bent fabric sheets.

Exceptions

Exception Condition
Autodesk.Revit.Exceptions ArgumentException When setting this property: the data-setting method is not applicable to fabric sheets that are flat
Autodesk.Revit.Exceptions ArgumentOutOfRangeException When setting this property: A value passed for an enumeration argument is not a member of that enumeration
Autodesk.Revit.Exceptions DisabledDisciplineException When setting this property: None of the following disciplines is enabled: Structural.
Autodesk.Revit.Exceptions InvalidObjectException When setting this property: The data-setting method is not applicable to fabric sheets that are flat.

See Also