BuiltInFailures.OpeningFailures Members


Provides a container of all Revit built-in FailureDefinitionId instances.

The BuiltInFailures OpeningFailures type exposes the following members.

Properties

Name Description
Public property Static member HostForCutHasNoGeometry
Host can't be cut because it has no geometry.
Public property Static member HostForCutHasNoGeometryWarn
Host can't be cut because it has no geometry.
Public property Static member InvalidComplexCut
The family [Family Name] was containing one or more invalid cuts, which have been removed (most likely it was cutting a curtain wall). Please examine the family and make changes as needed.\r\nHint 1: If you are trying to cut a Curtain Wall, you may be able to achieve the desired result by editing the Elevation Profile or the curtain panel.\r\n Hint 2: If you can't see the family, you can still select it from the Project Browser.\r\nHint 3: This warning will disappear after you edit and then finish the family.
Public property Static member OpeningCutAll
Opening completely removes its host
Public property Static member OpeningDoesnotCutHost
Opening does not cut its host.
Public property Static member OpeningDoesnotCutHostDelete
Opening does not cut its host.
Public property Static member OpeningNegativeHeight
The top of the Opening is lower than the bottom of the Opening or coincident with it.
Public property Static member OpeningPartiallyCutsHost
Opening partially cuts its host.
Public property Static member OpeningRectDoesnotCutHost
Rectangular opening doesn't cut its host.
Public property Static member OpeningRemovesHost
Opening completely removes its host.
Public property Static member OpenStringerConflictNosing
Open stringer can't be created for selected nosing profile. Set nosing profile to default to get open stringers created.
Public property Static member PropertyNotClosed
Property lines do not form a closed loop. Area will not be computed.

See Also