•  

Tolerance Property

Allows control over the match criteria by using a tolerance in the geometry comparison. It is suggested to use this in cases where trivial differences should be considered when matching elements.

Namespace: Autodesk.Revit.DB
Assembly: RevitAPI (in RevitAPI.dll) Version: 2015.0.0.0 (2015.0.0.0)
Since: 2011

Syntax

C# 
public double Tolerance { get; set; }
Visual Basic 
Public Property Tolerance As Double
	Get
	Set
Visual C++ 
public:
property double Tolerance {
	double get ();
	void set (double value);
}

Remarks

By default this is set to zero, but depending on your units of measure and how close objects may be, it is advised to set this to something more realistic. If the tolerance is positive, the point may lie up to the tolerance amount outside the outline to be matched. If the tolerance is negative, the point must lie at least the tolerance amount inside the outline to be matched.

See Also