•  

SetLayoutAsMinimumClearSpacing Method

Sets the Layout Rule property of rebar set to MinimumClearSpacing

Namespace: Autodesk.Revit.DB.Structure
Assembly: RevitAPI (in RevitAPI.dll) Version: 18.0.0.0 (18.0.0.420)
Since: 2009

Syntax

C# 
[ObsoleteAttribute("This method is deprecated in Revit 2018 and will be removed in a future version. Use GetShapeDrivenAccessor().SetLayoutAsMinimumClearSpacing() instead.")]
public void SetLayoutAsMinimumClearSpacing(
	double spacing,
	double arrayLength,
	bool barsOnNormalSide,
	bool includeFirstBar,
	bool includeLastBar
)
Visual Basic 
<ObsoleteAttribute("This method is deprecated in Revit 2018 and will be removed in a future version. Use GetShapeDrivenAccessor().SetLayoutAsMinimumClearSpacing() instead.")> _
Public Sub SetLayoutAsMinimumClearSpacing ( _
	spacing As Double, _
	arrayLength As Double, _
	barsOnNormalSide As Boolean, _
	includeFirstBar As Boolean, _
	includeLastBar As Boolean _
)
Visual C++ 
[ObsoleteAttribute(L"This method is deprecated in Revit 2018 and will be removed in a future version. Use GetShapeDrivenAccessor().SetLayoutAsMinimumClearSpacing() instead.")]
public:
void SetLayoutAsMinimumClearSpacing(
	double spacing, 
	double arrayLength, 
	bool barsOnNormalSide, 
	bool includeFirstBar, 
	bool includeLastBar
)

Parameters

spacing
Type: System Double
The maximum spacing between rebar in rebar set
arrayLength
Type: System Double
The distribution length of rebar set
barsOnNormalSide
Type: System Boolean
Identifies if the bars of the rebar set are on the same side of the rebar plane indicated by the normal
includeFirstBar
Type: System Boolean
Identifies if the first bar in rebar set is shown
includeLastBar
Type: System Boolean
Identifies if the last bar in rebar set is shown

Remarks

When changing the layout rule to MinimumClearSpacing, you must also simultaneously set Spacing, SetLength, BarsOnNormalSide, IncludeFirstBar, and IncludeLastBar properties.

Exceptions

Exception Condition
Autodesk.Revit.Exceptions ArgumentOutOfRangeException The spacing isn't bigger than 0.0. -or- the set length arrayLength isn't acceptable.
Autodesk.Revit.Exceptions DisabledDisciplineException None of the following disciplines is enabled: Structural.
Autodesk.Revit.Exceptions InapplicableDataException This Rebar is an instance of a spiral or multiplanar shape.
Autodesk.Revit.Exceptions InvalidOperationException This method applies only to shape driven rebar.

See Also