IRebarUpdateServer Members


The IRebarUpdateServer type exposes the following members.

Methods

Name Description
Public method GenerateCurves
This function is supposed to calculate the bars in set based on data received in curvesData parameter.
Public method GetCustomHandleName
This function should return the name of the handle.
Public method GetCustomHandles
This function should define all handles that the Rebar has. This function is called when the Rebar is created.
Public method GetDescription
Implement this method to return a description of the server.
(Inherited from IExternalServer .)
Public method GetHandlesPosition

This function is supposed to provide the positions of handles defined in GetCustomHandles(). These positions will be shown on screen when the bar constraints are edited. If a position for a handle isn't provided, that handle will not be represented on screen while edit constraints.

This function is called when edit constraints command is lunched or during edit constraints after a constraint was changed and the curve calculation was done.

Public method GetName
Implement this method to return the name of the server.
(Inherited from IExternalServer .)
Public method GetServerId
Implement this method to return the id of the server.
(Inherited from IExternalServer .)
Public method GetServiceId
Implement this method to return the id of the service.
(Inherited from IExternalServer .)
Public method GetVendorId
Implement this method to return the id of the vendor of the server.
(Inherited from IExternalServer .)
Public method TrimExtendCurves
This function is supposed to trim or extend curves that were obtained from calling GenerateCurves(). Also in this function can be set new constraints for start and end handles.

See Also