Creates a new flexible pipe into the document, using a point array and flex pipe type.

Namespace: Autodesk.Revit.DB.Plumbing
Assembly: RevitAPI (in RevitAPI.dll) Version: 22.0.0.0 (22.1.0.0)
Since: 2014

Syntax

C#
`public static FlexPipe Create( Document document, ElementId systemTypeId, ElementId pipeTypeId, ElementId levelId, XYZ startTangent, XYZ endTangent, IList<XYZ> points )`

Visual Basic

Visual Basic
`Public Shared Function Create ( _ document As Document, _ systemTypeId As ElementId, _ pipeTypeId As ElementId, _ levelId As ElementId, _ startTangent As XYZ, _ endTangent As XYZ, _ points As IList(Of XYZ) _ ) As FlexPipe`

Public Shared Function Create ( _
	document As Document, _
	systemTypeId As ElementId, _
	pipeTypeId As ElementId, _
	levelId As ElementId, _
	startTangent As XYZ, _
	endTangent As XYZ, _
	points As IList(Of XYZ) _
) As FlexPipe

Visual C++
`public: static FlexPipe^ Create( Document^ document, ElementId^ systemTypeId, ElementId^ pipeTypeId, ElementId^ levelId, XYZ^ startTangent, XYZ^ endTangent, IList<XYZ^>^ points )`

Parameters

document: Type: Autodesk.Revit.DB Document
The document.

systemTypeId: Type: Autodesk.Revit.DB ElementId
The id of the piping system type.

pipeTypeId: Type: Autodesk.Revit.DB ElementId
The id of the flexible pipe.

levelId: Type: Autodesk.Revit.DB ElementId
The level id for the flexible pipe.

startTangent: Type: Autodesk.Revit.DB XYZ
The tangent vector at the start of the curve. The invalid or zero vector is ignored.

endTangent: Type: Autodesk.Revit.DB XYZ
The tangent vector at the end of the curve. The invalid or zero vector is ignored.

points: Type: System.Collections.Generic IList XYZ
The point array indicating the path of the flexible pipe, including the end point.

Return Value

If creation was successful then a new flexible pipe is returned, otherwise an exception with failure information will be thrown.

Exceptions

Exception	Condition
Autodesk.Revit.Exceptions ArgumentException	The systemTypeId is not valid piping system type. -or- The type pipeTypeId is not valid flexible pipe type. -or- The ElementId levelId is not a Level. -or- The valid number of points is less than two. In order to create a flex curve, at least two points are required. Note the duplicate points don't take into account.
Autodesk.Revit.Exceptions ArgumentNullException	A non-optional argument was null
Autodesk.Revit.Exceptions DisabledDisciplineException	None of the following disciplines is enabled: Mechanical Electrical Piping.

Create Method (Document, ElementId, ElementId, ElementId, XYZ, XYZ, IList(XYZ))

Syntax

Parameters

Return Value

Exceptions

See Also

Put AI to work inside Revit.