A choice of two reference points for one end of a constraint driving the length of a RebarShapeSegment.
Assembly: RevitAPI (in RevitAPI.dll) Version: 18.104.22.168 (22.214.171.1245)
|Straight||Refers to the end of the straight part of the segment: the point where the bend begins.|
|Exterior||Refers to the farthest point on the arc of the bend. Assuming the bend is 90 degrees or more, an Exterior constraint will be longer than a Straight constraint by an amount equal to the bend radius.|
The RebarShapeSegmentEndReferenceType of a constraint is meaningful only when the bend is right or obtuse . If the bend is acute , the reference type is ignored.