Winder |
Flag indicates whether curves are valid to use as base lines for winder path.
Namespace: Autodesk.Revit.DB.Architecture
Assembly: RevitAPI (in RevitAPI.dll) Version: 25.0.0.0 (25.0.0.0)
Syntax Members | Member name | Value | Description |
|---|---|---|
| Success | 0 | Indicates curves are valid to use as path base lines for winder run. This is only one flag indicates curves are fine to use as winder path. |
| NumberOutOfRange | 1 | The curves number is not 2 or 3. |
| Unbound | 2 | Curve is not bound. |
| Noncontinuous | 3 | The curves are not continuous in one loop. |
| NotOpenLoop | 4 | The curves are not in one open loop. |
| TooShort | 5 | Curve length is too short. |
| ColinearOrOverlap | 6 | Two curves are collinear or overlap. |
| SelfIntersect | 7 | The first curve intersect with third curve. |
| InvalidCurveType | 8 | Curve is not line. |
| NotSupported | 9 | This path(for zigzag winder) is not supported yet |
See Also