Curve By Points Utils Create Rectangle Method

public static void CreateRectangle(
	Document document,
	ReferencePoint startPoint,
	ReferencePoint endPoint,
	CurveProjectionType projectionType,
	bool boundaryReferenceLines,
	bool boundaryCurvesFollowSurface,
	out IList<ElementId> createdCurvesIds,
	out IList<ElementId> createdCornersIds
)

Public Shared Sub CreateRectangle ( 
	document As Document,
	startPoint As ReferencePoint,
	endPoint As ReferencePoint,
	projectionType As CurveProjectionType,
	boundaryReferenceLines As Boolean,
	boundaryCurvesFollowSurface As Boolean,
	<OutAttribute> ByRef createdCurvesIds As IList(Of ElementId),
	<OutAttribute> ByRef createdCornersIds As IList(Of ElementId)
)

public:
static void CreateRectangle(
	Document^ document, 
	ReferencePoint^ startPoint, 
	ReferencePoint^ endPoint, 
	CurveProjectionType projectionType, 
	bool boundaryReferenceLines, 
	bool boundaryCurvesFollowSurface, 
	[OutAttribute] IList<ElementId^>^% createdCurvesIds, 
	[OutAttribute] IList<ElementId^>^% createdCornersIds
)

static member CreateRectangle : 
        document : Document * 
        startPoint : ReferencePoint * 
        endPoint : ReferencePoint * 
        projectionType : CurveProjectionType * 
        boundaryReferenceLines : bool * 
        boundaryCurvesFollowSurface : bool * 
        createdCurvesIds : IList<ElementId> byref * 
        createdCornersIds : IList<ElementId> byref -> unit 

Parameters

document Document

The Document.

startPoint ReferencePoint

First diagonal point of rectangle.

endPoint ReferencePoint

Second diagonal point of rectangle.

projectionType CurveProjectionType

Projection type of rectangle's boundary curves. If the rectangle input points are Face hosted, and CurveProjectionType::ParallelToLevel is requested, and the Face normal at the location of the start point is at a less than 45 degree angle with the level planes, then the projectionType will be set to FromTopDown, even if ParallelToLevel was requested.

boundaryReferenceLines Boolean

True if rectangle's boundary curves should be reference lines, false otherwise.

boundaryCurvesFollowSurface Boolean

True if rectangle's boundary curves should follow surface, false otherwise.

createdCurvesIds IList ElementId

Created rectangle's boundary curves ids.

createdCornersIds IList ElementId

Ids of two newly created corner points.

Reference