Rebar Set Crank Ratio Override Method

Sets the crank ratio at the indicated bar end as an override value.

Namespace: Autodesk.Revit.DB.Structure
Assembly: RevitAPI (in RevitAPI.dll) Version: 26.0.4.0 (26.0.4.0)

Syntax

public void SetCrankRatioOverride(
	int end,
	double crankRatio
)

Public Sub SetCrankRatioOverride ( 
	end As Integer,
	crankRatio As Double
)

public:
void SetCrankRatioOverride(
	int end, 
	double crankRatio
)

member SetCrankRatioOverride : 
        end : int * 
        crankRatio : float -> unit

Parameters

end Int32: The bar end.
crankRatio Double: The crank ratio.

Exceptions

Exception	Condition
ArgumentOutOfRangeException	end must be 0 or 1.
InvalidOperationException	The bar does not have a valid Rebar Crank Type at the end. -or- The ability to override crank lengths is not enabled for this rebar instance. Use enableCrankLengthOverride(true) to enable it.

Remarks

The crank slope is 1/crankRatio. When the crank ratio is set, the crank offset length is keeping the same value. The angled length and straight length are adjusted.

Reference

Rebar Class

Autodesk.Revit.DB.Structure Namespace

SetCrankRatioOverride Method

Rebar Set Crank Ratio Override Method

Parameters

Reference

Stop fighting Revit automation.